Dmg In Gaming Means Name Free Microfiber Cloth
Dmg In Gaming Means Name How To Do This
Dmg In Gaming Means Name Mod Kit From

DPS is a measurement of damage that can be done by a weapon, spell, other equipment, player or group of players in an online game.

It is used as a metric in some games to allow a determination of offensive power.

DPS is also used to refer to certain classes of character that are picked for their ability to destroy and kill.

Damage Per Second is the most common definition for DPS on online gaming forums.

Here is an example of DPS being used in an online conversation.

Lightly put everything back together and give it a test run. 12. Put it back together if it works.

Dmg In Gaming Means Name How To Do This

I had a hard time trying to find a tutorial, so i had to go by their gallery pictures to figure out how to do this.

So here i present a how to just in case anyone here ever plans to do the same.

Dmg In Gaming Means Name Mod Kit From

Enjoy Courtesy of Nonfinite Electronics - Home What you need ------------------------- - 1.5mm Dual LED backlight mod kit from Nonfinite 15.

Commence to take apart the gameboy with the triwing screwdriver, theres a total of 6 screws on the back.

Carefully pry the casing open and separate to get a good look at your work space 2.

CAREFULLY, CAREFULLY use a flat head or xacto to pry up the lcd glass from the white plastic frame.

While its pryed up, put something underneath it so you can go ahead and snip out the plastic white frame at these two spots.

You have to remove this in order to have room for the Module to fit flat and proper.

Once youve snipped out the plastic frame piece, CAREFULLY use a fresh razor blade to peel off the lcd glass reflective film.

Its imperative that you take your time on peeling off the reflective film by hand.

Just use the razor to get a corner up, then use your fingers to do the rest.

Flip the lcd glass mainboard over and snip out or use desoldering braid like i did to remove the diode and resistor in the top corner.

While youre there, go ahead and solder the single small wire to the solder pad closest to the dial.

Wash your hands with soap and water to remove any grease or oils.

You dont wanna get fingerprints on either side of the lcd glass, or the polarized film, or the white part of the led module.

Dmg In Gaming Means Name Free Microfiber Cloth

If your polarized film, lcd glass, or led module has fingerprints, clean it with a lint free microfiber cloth.

Now its time to slide in your led module, once its slid in all the way, slide in your polarized film on top of it.

So the led module is on the bottom, next polarized film, then on top is the led glass.

Align it as best as you can taking note of the edges making sure theres no see through, no white showing, or areas where polarized film isnt covering.

Once you have it perfectly aligned, use a glue gun to keep it in place.

Now its time to solder that single wire (from the backside) to the same lead the heatshrinked lead is.

Youll have to snip off some of that lead to fit in the casing.

Now solder the resistor that came in the kit as displayed in the image.

This will goto your switch.

Corner dremeled out Separate pieces of electrical tape covering edges of switch and board 11.

Lightly put everything back together and give it a test run.

Put it back together if it works.